Mounting instructions

Mounting instructions executed by a professional
1) Check the cleanliness of BoosterGas to rise.
2) Install the propeller tip fuel supply.
3)
gasoline engine
(6-7 laps which is about 24cm Teflon).
ge then coat
slightly as silicone grease or spray.
there are no Teflon parte BoosterGas
after mounting.
exaggerate not pull the thread (the recommended torque
1 mkg.).
Rees with nipple. The recommended are tightened
is 3mkg.
nt 2 bits one after the other to distribute the
clamping load.
Mbout equipped
propeller should face fuel supply pipe (tank).
BoosterGas as close as possible to the chamber
combustion
nt contact with
hard hot spot or a point (foam)

Fit tips for the type and the diameter of the hose.
Put enough Teflon tape (reference: Gas Steam GEB) for
ensure a good seal, especially in the case of a
Always wrap the Teflon in the direction of vissa
Leave the first free net Teflon screw to make it easier
and especially
Screw caps with care to avoid damaging the threads, tighten
thoroughly without
Mounting truck do not forget to put the gaskets
liv aluminum
4) Tighten simultanéme

5) Check to make sure that the installation is performed on the hose
power and not fuel hose return e

6) Place the
:
– Input pump for diesel, in avoided

– Input direct injection
– Input from fuel rail
– Input carburetor
hard int,
by metallic otherwise provide protection class M1 example.

7
If the engine speed does not stabilize, there are two reasons:
wholesale engine size = & gt; set up
the model below
edent hose too important = & gt; this means shortening the
hose.

ier control must be
after 48 hours, optionally by the customer.
very important, especially
in the case of non-compliance with the recommended dosage.

s
Installation must be done by a professional heating contractor.
Avoid contact with a hot spot or a hot zone (example:
turbo) and avoid direct contact between the BoosterGas and a po
) Once mounted, the engine rotate at different speeds.
– Model BoosterGas too
– Or exc
8) Make a leak test with the finger. this prem
repeated

9) Pay special attention to mounting on vehicles using
Unleaded gasoline 95, because of the new additive Ethanol; request
also if the user does not use additives or types of MECATEC
others, who also have a solvent power
10) In the case of a mounting fuel boiler, it is necessary to
make some adjustments (nozzle, the flame front temperature
smoked).